Fluke 5200A AC Calibrator Update
I have been working on the fluke some more, I have been going through its basic calibration procedure (doing a video it of course).
I can see that TP5 on the oscillator control board is noisy, so this could be a clue to where the noise is originating.
As it is a closed loop system, I will need to inject my own signal at some point of the circuit to see if the noise is before or after that point.
I can see that TP5 on the oscillator control board is noisy, so this could be a clue to where the noise is originating.
As it is a closed loop system, I will need to inject my own signal at some point of the circuit to see if the noise is before or after that point.
Trackbacks
The author does not allow comments to this entry
Comments
Display comments as Linear | Threaded